2014 Hilux · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for RHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the RH side.


1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the connector under the seat.

  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Operate the power seat switch (slide switch) to move the seat to the rearmost position.

  1. B207075E01
    Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Operate the power seat switch (slide switch) to move the seat to the foremost position.

  1. B207074E01
    Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


2. INSTALL OUTER SEAT TRACK BRACKET COVER

  1. B108449E03
    Attach the 2 claws in the order shown in the illustration to install the outer seat track bracket cover.

    NOTICE:
    Be careful not to damage the claws.


3. INSTALL INNER SEAT TRACK BRACKET COVER

  1. B108448E03
    Attach the 2 claws in the order shown in the illustration to install the inner seat track bracket cover.

    NOTICE:
    Be careful not to damage the claws.


4. INSTALL FRONT SEAT HEADREST ASSEMBLY
  1. Install the front seat headrest assembly.


5. CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)

6. INSPECT FRONT SEAT ASSEMBLY
  1. Check the power seat operation (Click here).

  1. for LHD, w/ Seat Heater System:
    Check the seat heater operation.

    1. Turn the ignition switch to ON.

    2. Turn the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

← INSTALLATION (Jun 2011 – Jul 2012)INSTALLATION (from Aug 2013) →