REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for RHD vehicles.
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the RH side.
| 1.
REMOVE FRONT SEAT ASSEMBLY |
 |
(Click here)
| 2.
REMOVE RECLINING POWER SEAT SWITCH KNOB
|
 |
- Apply protective tape around the front seat cushion shield.
Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective Tape
|
| 3.
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
|
 |
- Apply protective tape around the front seat cushion shield.
Using a screwdriver, detach the 4 claws and remove the slide and vertical power seat switch knob.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective Tape
|
| 4.
REMOVE FRONT SEAT CUSHION SHIELD RH
|
 |
- Remove the 2 screws.
- Remove the 3 screws.
Detach the claw and guide.
Remove the front seat cushion shield RH.
| 5.
REMOVE FRONT POWER SEAT SWITCH RH |
 |
- Remove the 3 screws.
Disconnect the connector and remove the front power seat switch RH.