INSTALLATION
Removal / installation · Vehicles built from Aug 2013
- HINT:
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
- When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for smart GBOOK (Click here).
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
| 1. INSTALL NO. 2 RADIO BRACKET |
Install the No. 2 radio bracket to the navigation receiver assembly with the 3 screws.
| 2. INSTALL NO. 1 RADIO BRACKET |
Install the No. 1 radio bracket to the navigation receiver assembly with the 3 screws.
| 3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET |
Connect all the connectors.
Attach the wire harness clamp.
Insert the navigation receiver assembly with bracket to attach the 2 clips on its backside.
- NOTICE:
- When inserting the navigation receiver assembly, do not press the knobs on it.
Install the navigation receiver assembly with bracket with the 4 screws.
| 4. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
for Manual Air Conditioning System:
Connect the connectors.
Attach the 4 claws to connect the air conditioner control.
Attach the 10 claws and 4 clips to install the center instrument cluster finish panel.
for Automatic Air Conditioning System:
Connect the connectors.
Attach the 8 claws and 4 clips to install the center instrument cluster finish panel.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
