REMOVAL
Removal / installation · Vehicles built from Aug 2013
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
for Manual Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.

Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 10 claws and 4 clips.
Detach the 4 claws and disconnect the air conditioner control.

Disconnect the connectors and remove the center instrument cluster finish panel.
for Automatic Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.

Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 8 claws and 4 clips.
Disconnect the connectors and remove the center instrument cluster finish panel.
| 4. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET |
Remove the 4 screws.

Pull out the navigation receiver assembly to detach the 2 clips on the backside of the navigation receiver assembly with bracket.
Detach the wire harness clamp.

Disconnect all the connectors and remove the navigation receiver assembly with bracket.
| 5. REMOVE NO. 1 RADIO BRACKET |
Remove the 3 screws and No. 1 radio bracket from the navigation receiver assembly.

| 6. REMOVE NO. 2 RADIO BRACKET |
Remove the 3 screws and No. 2 radio bracket from the navigation receiver assembly.

