2014 Hilux · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for RHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the RH side.


1. REMOVE FRONT SEAT ASSEMBLY
(Click here)

2. REMOVE RECLINING POWER SEAT SWITCH KNOB

  1. B207076E02
    Apply protective tape around the front seat cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

  1. B207077E02
    Apply protective tape around the front seat cushion shield.

  1. Using a screwdriver, detach the 4 claws and remove the slide and vertical power seat switch knob.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


4. REMOVE FRONT SEAT CUSHION SHIELD RH

  1. B207078
    Remove the 2 screws.

  1. B207039
    Remove the 3 screws.

  1. Detach the claw and guide.

  1. Remove the front seat cushion shield RH.


5. REMOVE FRONT SEAT INNER CUSHION SHIELD RH

  1. B278519
    Remove the screw.

  1. Detach the claw and guide.

  1. B278520
    Pull the front seat inner cushion shield RH to detach the claw and remove the front seat inner cushion shield RH.


6. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (w/ Front Seat Side Airbag)

  1. B284720
    Detach the 4 front seat airbag wire harness clamps.

  1. B284721
    Disconnect the No. 1 seat wire connector and detach the wire harness clamp.

  1. B284722
    for LHD, w/ Seat Heater System:
    Detach the front seatback heater assembly LH wire harness clamp.

  1. B284723
    Remove the 2 screws, 4 bolts and separate type front seatback assembly.


7. REMOVE RECLINING ADJUSTER INSIDE COVER RH (w/ Front Seat Side Airbag)

  1. B284724
    Detach the guide and remove the reclining adjuster inside cover RH.


8. REMOVE RECLINING ADJUSTER INSIDE COVER LH (w/ Front Seat Side Airbag)

  1. B284725
    Detach the guide and remove the reclining adjuster inside cover LH.


9. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

  1. B284721
    w/o Front Seat Side Airbag:
    Disconnect the No. 1 seat wire connector and detach the wire harness clamp.

  1. B284726
    Remove the hog rings from the wires of the separate type front seatback cover, and then roll up the separate type front seatback cover.

  1. Pass the No. 1 seat wire through the hole of the separate type front seatback cover.

  1. B286377
    for LHD, w/ Seat Heater System:
    Pass the front seatback heater assembly LH wire harness through the hole of the separate type front seatback cover.

  1. B284728
    Remove the hog rings and detach the strap of the separate type front seatback cover, and then roll up the separate type front seatback cover and No. 1 seatback cloth.

  1. B284730
    Pass the strap of the separate type front seatback cover through the holes of the separate type front seatback pad.

  1. B284732
    w/ Front Seat Side Airbag:
    Remove the nut and detach the separate type front seatback cover bracket.

  1. Remove the hog rings and roll up the separate type front seatback cover.

    B284734E01

    Text in Illustration 
    *A
    w/o Front Seat Side Airbag
    *B
    w/ Front Seat Side Airbag
    *a
    Front view of front seatback
    *b
    Rear view of front seatback

  1. B207089
    Detach the 4 claws and remove the 2 front seat headrest supports and separate type front seatback cover from the separate type front seatback pad.


10. REMOVE SEPARATE TYPE FRONT SEATBACK PAD

  1. B207090
    Remove the separate type front seatback pad from the separate type front seatback spring assembly.


11. REMOVE NO. 1 SEATBACK CLOTH

  1. B277282
    Remove the No. 1 seatback cloth.


12. REMOVE RECLINING ADJUSTER INSIDE COVER RH

B207093
  1. Remove the screw.

  1. Detach the claw and remove the reclining adjuster inside cover RH.


13. REMOVE RECLINING ADJUSTER INSIDE COVER RH (w/o Front Seat Side Airbag)

B171585E02
  1. Remove the screw.

  1. Detach the guide and remove the reclining adjuster inside cover RH.


14. REMOVE RECLINING ADJUSTER INSIDE COVER LH (w/ Front Seat Side Airbag)

B207094
  1. Remove the screw.

  1. Detach the claw and remove the reclining adjuster inside cover LH.


15. REMOVE NO. 1 SEAT WIRE (w/ Front Seat Side Airbag)

  1. B286469
    w/ Front Seat Side Airbag:
    Disconnect the front power seat motor assembly (for Reclining) connector.

  1. Detach the 2 wire harness clamps and remove the No. 1 seat wire.


16. REMOVE POWER SEAT MOTOR ASSEMBLY (for Reclining, w/o Front Seat Side Airbag)

B277631
  1. Detach the 8 hooks and remove the seatback spring.

  1. Disconnect the connector.

  1. B207099
    Detach the 6 claws and remove the push nut from the reclining rod.

  1. B206606
    Remove the reclining rod.

  1. B206607
    Using a 4 mm socket hexagon wrench, remove the 3 bolts and power seat motor assembly (for Reclining).

← REMOVAL (Aug 2012 – Jul 2013)INSPECTION (from Jun 2011) →