Slip Indicator Light Remains ON
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
If the skid control ECU (brake actuator assembly) stores a DTC, the slip indicator light in the combination meter comes on.The slip indicator light blinks during VSC and TRC operation.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the brake actuator assembly, perform calibration (Click here).
- Before disconnecting the connector, make sure that there are no problems with the connection.
- After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
- After replacing the brake actuator assembly, perform calibration (Click here).
| 1. CHECK FOR DTC |
Check if DTCs for the VSC are output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
Slip Indicator Light
Slip indicator light
Indicator light ON / OFF
Observe the combination meter.
When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.
| Tester Display |
Measurement Item / Range |
Normal Condition |
Diagnostic Note |
| Slip Indicator Light |
Slip indicator light / ON or OFF |
ON: Slip indicator light on OFF: Slip indicator light off |
- |
| Result |
Proceed to |
||
| Data List Display |
Data List Display When Performing Active Test ON/OFF Operation |
||
| ON |
Does not change between ON and OFF |
for LHD |
A |
| Does not change between ON and OFF |
for RHD |
B |
|
| Changes between ON and OFF |
C |
||
| OFF |
Does not change between ON and OFF |
for LHD |
A |
| Does not change between ON and OFF |
for RHD |
B |
|
| Changes between ON and OFF |
C |
||
|
|
||||
|
|
||||
| A | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Disconnect the C26 combination meter connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
S35-3 (IND) - C26-17
Always
Below 1 Ω
S35-3 (IND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
