2014 Hilux · Service Manual BODY ELECTRICAL

Navigation Receiver Assembly Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2013

DESCRIPTION

This circuit provides power to the navigation receiver assembly.

WIRING DIAGRAM

E278696E03

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)

  1. E178447E77
    Disconnect the navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N12-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    N12-4 (B) - Body ground
    Always
    11 to 14 V
    N12-3 (ACC) - Body ground
    Ignition switch ACC
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Navigation Receiver Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter (from Aug 2013)COMPONENTS (from Aug 2013) →