2014 Hilux · Service Manual BODY ELECTRICAL

Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Aug 2013

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM

E278321E07

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the N9 navigation receiver assembly connector.

  1. Disconnect the N14 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N9-13 (VV+) - N14-6 (VV+)
    Always
    Below 1 Ω
    N9-14 (VV-) - N14-11 (VV-)
    Always
    Below 1 Ω
    N9-13 (VV+) - Body ground
    Always
    10 kΩ or higher
    N9-14 (VV-) - Body ground
    Always
    10 kΩ or higher
    N9-12 (SG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Microphone Circuit between Microphone and Navigation Receiver Assembly (from Aug 2013)Navigation Receiver Assembly Power Source Circuit (from Aug 2013) →