2014 Hilux · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


3. REMOVE FRONT FLEXIBLE HOSE

  1. C111360
    Remove the union bolt and gasket.

  1. Disconnect the flexible hose from the brake cylinder.


4. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

  1. C111361
    Remove the 2 bolts and disc brake cylinder assembly.


5. REMOVE NO. 1 CYLINDER SLIDE BUSH

  1. C238099
    Remove the No. 1 cylinder slide bush from the disc brake cylinder assembly.


6. REMOVE NO. 2 CYLINDER SLIDE BUSH
  1. Remove the No. 2 cylinder slide bush from the disc brake cylinder assembly.


7. REMOVE FRONT DISC BRAKE BUSH DUST BOOT

  1. C238098
    Remove the 4 boots from the disc brake cylinder assembly.


8. REMOVE NO. 1 COLLAR
  1. Remove the No. 1 collar from the disc brake cylinder assembly.


9. REMOVE NO. 2 COLLAR
  1. Remove the No. 2 collar from the disc brake cylinder assembly.


10. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 front disc brake pads from the disc brake cylinder assembly.


11. REMOVE FRONT ANTI-SQUEAL SHIM KIT
  1. Remove the No. 1 anti-squeal shim and No. 2 anti-squeal shim from each pad.


12. REMOVE PAD WEAR INDICATOR PLATE
  1. Remove the pad wear indicator plates from the disc brake pad.


13. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 4 pad support plates from the brake cylinder mounting.


14. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH
  1. Remove the 2 bolts and cylinder mounting.


15. REMOVE FRONT DISC

  1. C111369E01
    Put matchmarks on the disc and axle hub.

  1. Remove the disc.

← COMPONENTS (from Jun 2011)DISASSEMBLY (from Jun 2011) →