2014 Hilux · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE CYLINDER BOOT

  1. C111363E01
    Using a screwdriver, pry out the set ring and boot.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the brake piston and cylinder.


2. REMOVE FRONT DISC BRAKE PISTON

  1. C111364E11
    Prepare a wooden plate to hold the piston.

  1. C111365
    Place the wooden plate between the piston and cylinder.

  1. Use compressed air to remove the piston from the cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.


3. REMOVE PISTON SEAL

  1. C111366E01
    Using a screwdriver, pry out the seal from the cylinder.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the inner cylinder and cylinder groove.


4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

5. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug from the cylinder.

← REMOVAL (from Jun 2011)INSPECTION (from Jun 2011) →