2014 Hilux · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE REAR NO. 1 OUTER SEAT BELT ASSEMBLY LH
(Click here)

4. REMOVE REAR AIRBAG SENSOR LH

  1. B282112
    Remove the nut and rear airbag sensor LH.

  1. Disconnect the connector.

← REMOVAL (Jun 2011 – Jul 2012)REMOVAL (from Aug 2013) →