REMOVAL
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| 2.
REMOVE REAR SEAT ASSEMBLY |
 |
Remove the rear seat assembly (Click here).
| 3.
REMOVE REAR DOOR SCUFF PLATE LH
|
 |
Put protective tape around the rear door scuff plate LH.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 7 claws and 2 clips, and remove the rear door scuff plate LH.
| 4.
REMOVE REAR DOOR OPENING TRIM LH |
|
| 5.
REMOVE LOWER QUARTER TRIM PANEL LH
|
 |
w/o Rear Center Seat Belt:
Detach the claw and 3 clips and remove the lower quarter trim panel LH.
- w/ Rear Center Seat Belt:
Detach the claw and 3 clips and remove the lower quarter trim panel LH.
| 6.
REMOVE REAR AIRBAG SENSOR LH |
 |
- Remove the bolt and rear airbag sensor.
Disconnect the connector.