2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

  1. A258390E01
    Install 2 new clips, the No. 6 exhaust pipe air hose and No. 7 exhaust pipe air hose to the differential pressure sensor.

    HINT:
    1. Connect the air hoses so that the paint marks of the air hoses are as shown in the illustration.
    2. Make sure the clips are as shown in the illustration.

    Text in Illustration 
    *1
    Marking
    *2
    Green Paint Mark
    *3
    Orange Paint Mark
    *4
    New Clip
    *a
    CORRECT
    *b
    INCORRECT
    *c
    14.3 mm (0.562 in.) or less
    *d
    Clip must not protrude past end of hose

  1. Install the differential pressure sensor with the nut.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. for Automatic Transmission:

    1. Install the sensor bracket with the bolt.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    2. Attach the 2 clamps and connect the connector.

  1. for Manual Transmission:
    Connect the connector.


2. INSTALL NO. 1 FRONT FLOOR HEAT INSULATOR
  1. Install the No. 1 front floor heat insulator with the 3 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }


3. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)
← REMOVAL (from Jun 2011)COMPONENTS (from Jun 2011) →