INSTALLATION
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY |
Install 2 new clips, the No. 6 exhaust pipe air hose and No. 7 exhaust pipe air hose to the differential pressure sensor.

- HINT:
- Connect the air hoses so that the paint marks of the air hoses are as shown in the illustration.
- Make sure the clips are as shown in the illustration.
- Connect the air hoses so that the paint marks of the air hoses are as shown in the illustration.
Text in Illustration *1
Marking
*2
Green Paint Mark
*3
Orange Paint Mark
*4
New Clip
*a
CORRECT
*b
INCORRECT
*c
14.3 mm (0.562 in.) or less
*d
Clip must not protrude past end of hose
Install the differential pressure sensor with the nut.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
for 4WD:
Connect the connector.
for Pre-Runner:
Install the sensor bracket with the bolt.
- Torque:
- 20 N*m{ 199 kgf*cm , 14 ft.*lbf }
Connect the connector.
| 2. INSTALL NO. 1 FRONT FLOOR HEAT INSULATOR |
Install the No. 1 front floor heat insulator with the 3 nuts.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
| 3. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
