CB-43 USB Device Class/Protocol Error
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012
Also covers:
- CB-44 USB File System Error
- CB-50 iPod Malfunction
- CB-51 iPod Protocol Error
- CB-7D iPod Protocol Unsupported
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| CB-43 |
A non-mass-storage class or USB device with an incompatible protocol is connected. |
|
| CB-44 |
An incompatible file system or USB device with a corrupted or incompatible File Allocation Table (FAT) is connected. |
|
| CB-50 |
"iPod" malfunction |
|
| CB-51 |
An "iPod" with unsupported firmware is connected. |
|
| CB-7D |
An unsupported model of "iPod" is connected. |
INSPECTION PROCEDURE
- NOTICE:
- The data stored on the USB device or "iPod" may be changed or lost due to malfunctions, repairs, system errors, etc. Therefore, when repairs are to be performed, explain this to the customer and obtain their consent prior to performing repairs.
- HINT:
- After the inspection is completed, clear the DTCs.
| 1. REPLACE USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the stereo jack adapter assembly.
Turn the ignition switch off.
- HINT:
- When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter assembly.
- HINT:
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
- Refer to System Description for compatible formats and versions (Click here).
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
| NEXT | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs and check if the same DTC occurs again.
- HINT:
- If DTCs are output frequently, replace the radio receiver assembly.
- OK:
- Malfunction disappears.
|
|
||||
| OK | ||
| ||
