CB-45 USB Communication Error
Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013
Also covers:
- CB-46 iPod Control Error
- CB-47 iPod Communication Error
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| CB-45 |
A communication error with USB device. |
|
| CB-46 |
An "iPod" control software malfunction. |
|
| CB-47 |
A communication error with "iPod". |
INSPECTION PROCEDURE
- NOTICE:
- The data stored on the USB device or "iPod" may be changed or lost due to malfunctions, repairs, system errors, etc. Therefore, when repairs are to be performed, explain this to the customer and obtain their consent prior to performing repairs.
- HINT:
- After the inspection is completed, clear the DTCs.
| 1. REPLACE USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the stereo jack adapter assembly.
Turn the ignition switch off.
- HINT:
- When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter assembly.
- HINT:
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
| NEXT | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs and check if the same DTC occurs again.
- HINT:
- If DTCs are output frequently, replace the radio receiver assembly.
- OK:
- Malfunction disappears.
|
|
||||
| OK | ||
| ||
