2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2012


INSPECT VACUUM SWITCHING VALVE (for EGR Cut)
  1. Inspect the vacuum switching valve.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      37 to 44 Ω
      1 - Body ground
      2 - Body ground
      20°C (68°F)
      1 MΩ or higher

      If the result is not as specified, replace the vacuum switching valve.

  1. Check the operation of the vacuum switching valve.

    1. A151248E06
      Attach a vacuum pump to port E and check that air does not flow from the filter to port E.
      Text in Illustration 
      *1
      Port E
      *2
      Filter

    2. A151249E05
      Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Filter

    3. Attach a vacuum pump to port E and check that air flows from the filter to port E.
      If the result is not as specified, replace the vacuum switching valve.

← REMOVAL (from Aug 2012)INSTALLATION (from Aug 2012) →