2014 Hilux · Service Manual DRIVE LINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY

  1. C237690E01
    Measure the resistance between terminals 1 and 2.
    Text in Illustration 
    *1
    Shift Fork
    *a
    2WD Side
    *b
    4WD Side

    Standard:
    0.1 to 100 Ω

  1. Measure the resistance between terminal 1 or 2 and body ground.

    Standard:
    5 MΩ or more

    If the result is not as specified, replace the differential vacuum actuator.

  1. Check the actuator using one of the following methods.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Measurement Condition
      Specified Condition
      3 - 4
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Below 1 Ω
      3 - 4
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      10 kΩ or higher
      4 - 5
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Below 1 Ω
      4 - 5
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      10 kΩ or higher
      4 - 6
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Below 1 Ω
      4 - 6
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      10 kΩ or higher

      If the result is not as specified, replace the actuator.

    2. Check the actuator status.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      2WD → 4WD
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      4WD → 2WD

      If the result is not as specified, replace the actuator.

← REMOVAL (from Jun 2011)INSTALLATION (from Jun 2011) →