2014 Hilux · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. REMOVE NO. 1 ENGINE UNDER COVER

2. REMOVE NO. 2 ENGINE UNDER COVER

3. DRAIN DIFFERENTIAL OIL

  1. for front differential:

    1. Stop the vehicle on a level surface.

    2. A272242E01
      Using SST and the 10 mm straight hexagon wrench, 10 mm union nut wrench and socket adaptor, remove the differential filler plug and gasket.
      SST
      09961-00950  
      Text in Illustration 
      *1
      10 mm Straight Hexagon Wrench
      *2
      10 mm Union Nut Wrench
      *3
      Socket Adaptor

    3. Remove the drain plug and gasket, and drain the oil.

    4. Install a new gasket and the drain plug.

      Torque:
      65 N*m{ 660 kgf*cm , 48 ft.*lbf }

  1. for rear differential:

    1. Stop the vehicle on a level surface.

    2. Remove the differential filler plug and gasket.

    3. Remove the drain plug and gasket, and drain the oil.

    4. Install a new gasket and the drain plug.

      Torque:
      49 N*m{ 500 kgf*cm , 36 ft.*lbf }


4. REMOVE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY
  1. Remove the bolt and disconnect the differential breather tube bracket.

  1. Support the differential with a jack.

  1. C237474E01
    Remove the No. 1 differential mounting nut.
    Text in Illustration 
    *1
    Mounting Bolt
    *2
    Mounting Nut

  1. Remove the 2 mounting bolts and 2 nuts.

  1. Lower the jack.

  1. Disconnect the connector.

  1. C237694
    Remove the 4 bolts.

  1. Using a hammer, pry out the actuator from the differential tube.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →