Parking Brake Switch Circuit
Circuit diagnosis · Vehicles built from Aug 2013
DESCRIPTION
This circuit includes the parking brake switch assembly and navigation receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK VEHICLE SIGNAL (OPERATION CHECK) |
Display the "Vehicle Signal Check Mode" screen (Click here).

Check that the display changes between ON and OFF according to the parking brake operation.
- OK:
Parking Brake Condition
Display
Applied
ON
Released
OFF
- HINT:
- This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY) |
Disconnect the N9 navigation receiver assembly connector.
Disconnect the P2 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
N9-15 (PKB) - P2-1
Always
Below 1 Ω
N9-15 (PKB) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT PARKING BRAKE SWITCH ASSEMBLY |
Remove the parking brake switch assembly (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
Switch connector - Switch body
On (Shaft is not pressed)
Below 1 Ω
Off (Shaft is pressed)
10 kΩ or higher
Text in Illustration 

On


Off
|
|
||||
| OK | ||
| ||
