DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. REMOVE RECIRCULATION DAMPER SERVO SUB-ASSEMBLY |
Detach the claw and remove the lever.

Text in Illustration *1
Lever
Remove the 3 screws and recirculation damper servo sub-assembly.

| 2. REMOVE CLEAN AIR FILTER |
![]() ![]() |
Detach the claw and remove the air filter case.
Remove the clean air filter.
| 3. REMOVE BLOWER MOTOR CONTROL |
w/o PTC Heater:

Disconnect the 2 connectors and detach the 2 clamps and wire harness.
w/ PTC Heater:
Disconnect the 4 connectors and detach the 3 clamps and wire harness.Text in Illustration *A
w/o PTC Heater
*B
w/ PTC Heater
Remove the 3 screws and blower motor with fan sub-assembly.

| 4. REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY |
![]() ![]() |
Disconnect the connector.
Remove the 2 screws and blower motor control.


