REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL BLOWER MOTOR WITH FAN SUB-ASSEMBLY |
Install the blower motor with fan sub-assembly with the 3 screws.
w/o PTC Heater:
Connect the 2 connectors and attach the 2 clamps and wire harness.
w/ PTC Heater:
Connect the 4 connectors and attach the 3 clamps and wire harness.
| 2. INSTALL BLOWER MOTOR CONTROL |
Install the blower motor control with the 2 screws.
Connect the connector.
| 3. INSTALL CLEAN AIR FILTER |
Install the clean air filter.
Attach the claw to install the air filter case.
| 4. INSTALL RECIRCULATION DAMPER SERVO SUB-ASSEMBLY |
Install the recirculation damper servo sub-assembly with 3 screws.
Attach the claw to install the recirculation damper servo sub-assembly.
