2014 Hilux · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT ASSEMBLY
(Click here)

2. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
(Click here)

3. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
(Click here)

4. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

B278169E01
  1. Remove the 2 screws.

  1. Detach the 2 hooks in the order shown in the illustration and remove the front seat inner cushion shield LH.


5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

  1. B278171E01
    Raise the reclining adjuster release handle LH to reveal the claw. Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


6. REMOVE FRONT SEAT CUSHION SHIELD LH

B278172E01
  1. Remove the 2 screws.

  1. Detach the 2 hooks in the order shown in the illustration, and then detach the guide and remove the front seat cushion shield LH.

    Text in Illustration 
    *1
    Hook
    *2
    Guide


7. REMOVE SEATBACK SPRING LH

  1. B277649
    Remove the seatback spring LH.


8. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

  1. B278534
    Detach the 3 front seat airbag wire harness clamps.

  1. B278535
    Remove the hog rings and fold back the separate type front seat cushion cover and rubber bands of the separate type front seatback cover.

  1. B278537
    for LHD, w/ Seat Heater System:
    Disconnect the front seatback heater assembly LH connector.

  1. B278538
    Remove the 4 bolts and separate type front seatback assembly.


9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

  1. B284711
    for LHD, w/ Seat Heater System:
    Detach the 3 front seat cushion heater assembly LH wire harness clamps.

  1. B278178
    for Front Passenger Side, w/ Seat Belt Warning System:
    Detach the wire harness clamp.

  1. B278179
    Remove the hog rings.

  1. B278180
    Bend the 2 front seat cushion frame claws upward.

  1. Detach the hooks and remove the separate type front seat cushion cover together with the pad from the front seat cushion frame sub-assembly LH.

    B278181

  1. B207624
    Remove the hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.


10. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH

  1. B284712
    Cut off the tack pins which hold down the front seat cushion heater assembly LH, and then remove the front seat cushion heater assembly LH from the separate type front seat cushion cover.

    NOTICE:
    Be careful not to damage the separate type front seat cushion cover.

← COMPONENTS (from Aug 2013)REMOVAL (Aug 2012 – Jul 2013) →