2014 Hilux · Service Manual BODY ELECTRICAL

B158F AV Signal Stoppage (Low Battery Voltage)

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily.
DTC No.
DTC Detection Condition
Trouble Area
B158F
A video or audio signal is interrupted when the battery voltage drops.
Radio and display receiver assembly

WIRING DIAGRAM

E278019E07

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.

HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for T-Connect.


1. CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. E268487
    Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (Click here)]

  1. Check that the battery voltage.

    Standard voltage:
    11 to 14 V

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



NG
Go to step 3
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    No DTCs are output.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)

3. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)

  1. E277492E41
    Disconnect the radio and display receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    R23-4 (B) - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Radio and Display Receiver Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)


← B1585 USB Device Malfunction (from Aug 2013)B15A0 LAN Master Malfunction (+ 6 more codes) (Aug 2012 – Jul 2013) →