2014 Hilux · Service Manual BODY ELECTRICAL

Display Signal Circuit between Radio Receiver and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Aug 2013

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E278190E07

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the R21 radio and display receiver assembly connector.

  1. Disconnect the N14 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R21-13 (VV+) - N14-6 (VV+)
    Always
    Below 1 Ω
    R21-14 (VV-) - N14-11 (VV-)
    R21-13 (VV+) - Body ground
    Always
    10 kΩ or higher
    R21-14 (VV-) - Body ground
    R21-12 (SG) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Microphone Circuit between Microphone and Radio Receiver (from Aug 2013)Radio Receiver Power Source Circuit (Jun 2011 – Jul 2012) →