Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
Circuit diagnosis · Vehicles built from Aug 2013
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the R30 radio and display receiver assembly connector.
Disconnect the N14 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R30-2 (US1-) - N14-2 (US1-)
Always
Below 1 Ω
R30-3 (US1+) - N14-3 (US1+)
R30-2 (US1-) - Body ground
Always
10 kΩ or higher
R30-3 (US1+) - Body ground
|
|
||||
| OK | ||
| ||
