2014 Hilux · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

The No. 1 stereo jack adapter assembly sends an external device sound signal to the radio and display receiver assembly through this circuit.
The sound signal that has been sent is amplified by the radio and display receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

E278677E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the R21 radio and display receiver assembly connector.

  1. Disconnect the N14 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R21-28 (VAL+) - N14-8 (VAL+)
    Always
    Below 1 Ω
    R21-26 (VAR+) - N14-7 (VAR+)
    R21-27 (VA-) - N14-9 (VA-)
    R21-11 (AGND) - N14-12 (AGND)
    R21-25 (ADPG) - N14-10 (ADPG)
    R21-28 (VAL+) - Body ground
    Always
    10 kΩ or higher
    R21-26 (VAR+) - Body ground
    R21-27 (VA-) - Body ground
    R21-11 (AGND) - Body ground
    R21-25 (ADPG) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (Aug 2012 – Jul 2013)Data Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Aug 2013) →