Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2012.01–2012.04
RM1840EF _V1 General _009564 INTRODUCTION _0051870 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL


Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed See page
Circling calibration Compass (Click here)
for Driver Side, w/ Jam Protection
Power window regulator motor initialization
·

Jam protection function

·

Power window control system (w/ Jam Protection Function)


(Click here)


NOTICE:

w/ Navigation System:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Procedures Necessary when ECU or Other Parts are Replaced
Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed See page
ECM (for 2TR-FBE) Register VIN DTC P0630 is output (Click here)
ECM (for 1KD-FTV, w/ EGR Cooler)
·

Learning values save

·

Learning values write


Engine starting (Click here)
Engine assembly (for 1KD-FTV, w/ EGR Cooler)
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
Fuel injector (for 1KD-FTV, w/ EGR Cooler)
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
Fuel supply pump (for 1KD-FTV, w/ EGR Cooler) Supply pump initialization Engine startability (Click here)
ECM (for 1KD-FTV, w/o EGR Cooler)
·

Learning values save

·

Learning values write


Engine starting (Click here)
Engine assembly (for 1KD-FTV, w/o EGR Cooler)
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
Fuel injector (for 1KD-FTV, w/o EGR Cooler)
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
Fuel supply pump (for 1KD-FTV, w/o EGR Cooler) Supply pump initialization Engine startability (Click here)
ECM (for 2KD-FTV, w/ EGR Cooler)
·

Learning values save

·

Learning values write


Engine starting (Click here)
Engine assembly (for 2KD-FTV, w/ EGR Cooler)
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
Fuel injector (for 2KD-FTV, w/ EGR Cooler)
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
Fuel supply pump (for 2KD-FTV, w/ EGR Cooler) Supply pump initialization Engine startability (Click here)
ECM (for 2KD-FTV, w/o EGR Cooler)
·

Learning values save

·

Learning values write


Engine starting (Click here)
Engine assembly (for 2KD-FTV, w/o EGR Cooler)
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
Fuel injector (for 2KD-FTV, w/o EGR Cooler)
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
Fuel supply pump (for 2KD-FTV, w/o EGR Cooler) Supply pump initialization Engine startability (Click here)
Skid control ECU (Brake actuator assembly) Yaw rate and acceleration sensor zero point calibration VSC (Click here)
·

Yaw rate and acceleration sensor

·

Front wheel alignment adjustment


·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC
for Built-in Type Door Control Receiver
·

Theft warning ECU assembly

·

Key


Recognition code registration Wireless door lock control system (Click here)
for Non-built-in Type Door Control Receiver
·

Door control receiver assembly

·

Key


Recognition code registration Wireless door lock control system (Click here)
·

Transponder key ECU assembly

·

ECM

·

Key


Code registration Engine starting Refer to the Service Bulletin for the registration procedure.
·

Telephone transceiver assembly

·

Instrument panel integration antenna assembly

·

Mayday battery


·

Set contract mode

·

Registration


Blocking system Refer to the Service Bulletin for the registration procedure.
Timing belt (for 1KD-FTV, 2KD-FTV) Mode reset operation
·

Does not illuminate when replacement is necessary

·

Illuminates when replacement is not necessary


(Click here)
for Driver Side, w/ Jam Protection
·

Front power window regulator motor

·

Front door window regulator

·

Power window regulator master switch


Motor initialization
·

Jam protection function

·

Power window control system (w/ Jam Protection Function)


(Click here)