1.INSTALL NO. 2 ECM BRACKET
Install the No. 2 ECM bracket with the 2 screws.
2.INSTALL NO. 1 ECM BRACKET
w/ Glow Plug Controller:
Install the No. 1 ECM bracket with the 2 screws.
w/o Glow Plug Controller:
Install the No. 1 ECM bracket with the 3 screws.
3.INSTALL ECM
Install the ECM with the bolt and 2 nuts.
w/ Glow Plug Controller:
Connect the 6 connectors.
w/o Glow Plug Controller:
Connect the 4 connectors.
4.INSTALL TRANSMISSION CONTROL ECU (for Automatic Transmission)
5.INSTALL TURBO MOTOR DRIVER (w/o Glow Plug Controller)
6.INSTALL 4WD CONTROL ECU (for 4WD)
7.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
8.PERFORM REGISTRATION
Perform registration (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for i-ART)>REGISTRATION).
Only perform registration when the ECM is replaced, either by itself or in any of the following combinations.
ECM and Fuel Supply Pump
ECM and Diesel Throttle Body Assembly
ECM and Injector Assembly
ECM and Engine Assembly
9.START ENGINE
When replacing the ECM, start the engine to initialize the new ECM (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for i-ART)>INITIALIZATION).