Home › Engine / Hybrid System › 1KD-FTV ENGINE CONTROL › INTAKE AIR TEMPERATURE SENSOR(w/ Glow Plug Controller) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009570 1KD-FTV ENGINE CONTROL _0052107 INTAKE AIR TEMPERATURE SENSOR(w/ Glow Plug Controller) A

1KD-FTV ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR(w/ Glow Plug Controller)  REMOVAL  


PROCEDURE

Hide 2.REMOVE INTAKE AIR TEMPERATURE SENSOR

a.

Disconnect the intake air temperature sensor connector.


b.
A272519

Using a 22 mm deep socket wrench, remove the intake air temperature sensor.

HINT:

Replace the intake air temperature sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the intake air temperature sensor each time the intercooler is replaced.