Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › MASS AIR FLOW METER
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052116 MASS AIR FLOW METER G

2TR-FBE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedures below.

·

Only replace the mass air flow meter when the mass air flow value in the DATA LIST (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 1.CHECK MASS AIR FLOW METER

a.

Read value using intelligent tester (MAF).

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.



i.

Turn the ignition switch to ON (do not run the engine).


ii.

Turn the intelligent tester on.


iii.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

Powertrain > Engine and ECT > Data List
Tester Display
MAF
50003 234 3

iv.

Wait 30 seconds and then read the values on the intelligent tester.

Standard Condition:
Item Condition Specified Condition
MAF
·

Engine not running

·

30 seconds after ignition switch is turned ON


Below 0.36 g/sec.


If the result is not as specified, replace the mass air flow meter.

If the result is within the specified range, inspect the mass air flow meter (See page Engine / Hybrid System>2TR-FBE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION).