The purpose of this circuit is to prevent the engine from stalling while driving in the lock-up condition when the brakes are suddenly applied.
When the brake pedal is depressed, the stop light switch sends a signal to the ECM. Then the ECM cancels the operation of the lock-up clutch while braking is in progress.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0724 | Brake Switch "B" Circuit High | The stop light switch remains on even when the vehicle is driven in a GO (30 km/h (18.63 mph) or more) and STOP (less than 3 km/h (1.86 mph)) pattern 5 times (2 trip detection logic). | ·
Stop light switch assembly signal circuit ·
Stop light switch assembly ·
ECM |
Comes on | DTC stored |
Refer to DTC P0504 (See page Engine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>P0504).
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Stop Light Switch.
| Tester Display |
|---|
| Stop Light Switch |
Read the value displayed on the tester when the brake pedal is depressed and released.
| Brake Pedal | Display |
|---|---|
| Released | OFF |
| Depressed | ON |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the stop light switch assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pin not pushed | Below 1 Ω |
| 3 - 4 | Pin not pushed | 10 kΩ or higher |
| 1 - 2 | Pin pushed | 10 kΩ or higher |
| 3 - 4 | Pin pushed | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G146-18 (STP) - Body ground | Brake pedal depressed | 11 to 14 V |
| G146-18 (STP) - Body ground | Brake pedal released | Below 1.5 V |
Reconnect the ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG