Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR › from 2012.04
RM1840EF _51 Engine / Hybrid System _009572 1GR-FE ENGINE CONTROL _0052139 AIR FUEL RATIO SENSOR A

1GR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

a.
A124820
0.865,0.479 0.479,0.979 0.479,0.979 0.479,1.115 true 1.906,1.052 2.094,1.219 0.188,0.167 10 true *1 0.375,1.177 0.677,1.354 0.302,0.177 10 false SST
*1 Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the air fuel ratio sensor connector.


Hide 2.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.
A124821
1.813,0.438 2.656,0.625 2.656,0.625 2.833,0.625 true 2.906,0.531 3.229,0.688 0.323,0.156 10 false SST 1.229,1.219 1.406,1.396 0.177,0.177 10 true *1
*1 Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the air fuel ratio sensor connector.