Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2012.04
RM1840EF _51 Engine / Hybrid System _009572 1GR-FE ENGINE CONTROL _0052140 HEATED OXYGEN SENSOR A

1GR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

a.
A112023
0.76,1.01 1.021,1.01 1.021,1.01 1.354,1.448 true 0.354,0.917 0.677,1.104 0.323,0.188 10 true SST 2.302,2.198 2.49,2.406 0.188,0.208 10 false *1
*1 Fulcrum Length


Using SST, install the heated oxygen sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the heated oxygen sensor connector.


Hide 2.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.
A112021
2.396,2.354 2.396,2.177 2.396,2.177 1.688,1.635 true 0.927,2.229 1.146,2.417 0.219,0.188 10 true *1 2.26,2.406 2.594,2.573 0.333,0.167 10 false SST
*1 Fulcrum Length


Using SST, install the heated oxygen sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the heated oxygen sensor connector.