1.INSTALL REAR CRANKSHAFT OIL SEAL
Apply MP grease to the lip of a new rear crankshaft oil seal.
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
The acceptable depth from the top of the oil seal retainer is 0 to 0.8 mm (0 to 0.315 in.)
Keep the lip free from foreign matter.
Do not tap the oil seal at an angle.
Make sure that the oil seal is properly installed.
2.INSTALL PUMP IMPELLER DRIVE PLATE (for Automatic Transmission)
3.INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)
4.INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)
5.INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)
6.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transmission)
7.INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
8.INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
for 2WD: (See page )