Home › Engine / Hybrid System › 2KD-FTV FUEL › FUEL SUPPLY PUMP(w/o DPF) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009578 2KD-FTV FUEL _0052216 FUEL SUPPLY PUMP(w/o DPF) A

2KD-FTV FUEL  FUEL SUPPLY PUMP(w/o DPF)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the fuel inlet pipe, clean it with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE RADIATOR ASSEMBLY

Hide 5.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE (w/ EGR Cooler)

Hide 6.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE (w/o EGR Cooler)

Hide 7.REMOVE FUEL INLET PIPE SUB-ASSEMBLY

a.
A301690
0.354,0.354 0.667,0.552 0.313,0.198 10 false *a 0.375,2.5 0.688,2.698 0.313,0.198 10 false *b
*a Common Rail Side
*b Fuel Supply Pump Side


Using a 17 mm union nut wrench, loosen the union nuts and remove the fuel inlet pipe.


Hide 8.REMOVE FUEL SUPPLY PUMP ASSEMBLY

a.
A231742

Disconnect the 2 fuel hoses.


b.
A231743

Disconnect the fuel temperature sensor connector and suction control valve connector.


c.
A070710

Remove the 4 bolts indicated by the arrows in the illustration.


d.

Remove the No. 2 camshaft timing pulley flange and pump drive shaft pulley.


e.
A301691
0.448,1.479 1.563,1.479 true 0.75,1.469 0.75,1.073 0.75,1.073 1.125,1.073 true 0.156,1.396 0.615,1.594 0.458,0.198 10 false SST

Remove the set nut and O-ring while holding the crankshaft pulley using SST.

SST
09213-58014  
09330-00021  


f.
A257066

Loosen the 2 nuts.


g.
A070714
2.115,0.76 2.781,0.76 true 2.885,0.656 3.344,0.854 0.458,0.198 10 false SST

Using SST, disconnect the fuel supply pump from the injection gear.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)

NOTICE:

Apply lubricant to the threads and tip of SST (center bolt) before using it.



h.

Remove the 2 nuts and fuel supply pump.

NOTICE:
·

Do not hold or carry the fuel supply pump by the pipe.

·

The fuel supply pump must be kept horizontal.




i.

Remove the O-ring.