Home › Engine / Hybrid System › 2KD-FTV INTAKE / EXHAUST › INTAKE MANIFOLD(w/o EGR Cooler) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009590 2KD-FTV INTAKE / EXHAUST _0052342 INTAKE MANIFOLD(w/o EGR Cooler) A

2KD-FTV INTAKE / EXHAUST  INTAKE MANIFOLD(w/o EGR Cooler)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE MANIFOLD STAY

A099622

a.

Remove the 2 bolts and manifold stay.


Hide 5.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

A099624

a.

Remove the engine oil level dipstick.


b.

Remove the bolt and injection pipe clamp.


c.

Remove the bolt and engine oil level dipstick guide.


d.

Remove the O-ring from the engine oil level dipstick guide.


Hide 6.REMOVE VACUUM SWITCHING VALVE BRACKET (w/o EGR System)

a.
A233088

Remove the 2 bolts and vacuum switching valve bracket.


Hide 7.REMOVE ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (w/ EGR System)

Hide 8.REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET

a.
A114779

Remove the 3 bolts and No. 2 intake air connector bracket.


Hide 9.REMOVE INTAKE AIR CONNECTOR

a.

Remove the 2 nuts, bolt, intake air connector and gasket.


Hide 10.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY (w/ EGR System)

Hide 11.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY (w/ EGR System)

Hide 12.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 13.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 14.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 15.REMOVE INTAKE MANIFOLD

A131656

a.

Remove the 2 nuts, 4 bolts, intake manifold and gasket.