Home › Engine / Hybrid System › 2TR-FBE FUEL › SOLENOID VALVE(for Fuel Cut Control) › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052252 SOLENOID VALVE(for Fuel Cut Control) A

2TR-FBE FUEL  SOLENOID VALVE(for Fuel Cut Control)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE SOLENOID VALVE ASSEMBLY

a.
A237773

Disconnect the No. 3 fuel hose, No. 2 fuel tube sub-assembly and connector.


b.
A237774

Remove the bolt and solenoid valve assembly.


c.
A238190

Remove 2 screws and remove the solenoid valve from the bracket.