Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL PRESSURE PULSATION DAMPER › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052255 FUEL PRESSURE PULSATION DAMPER A

2TR-FBE FUEL  FUEL PRESSURE PULSATION DAMPER  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.DISCONNECT NO. 1 FUEL HOSE

a.
A239218
1.604,2.635 1.604,2.833 false 1.531,2.875 1.75,3.052 0.219,0.177 10 false *1
*1 Fuel Hose Connector Cover


Disconnect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 5.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.
A239217

Remove the 2 bolts and fuel pressure pulsation damper.