Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL FILTER › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052256 FUEL FILTER A

2TR-FBE FUEL  FUEL FILTER  REPLACEMENT  


PROCEDURE

Hide 1.DISCHARGE DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE FUEL FILTER ASSEMBLY

a.
A237748

Disconnect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION).

NOTICE:
·

Check for dirt or mud contamination in the fuel hose and around the fuel hose's connector. Clean if necessary. Dirt or mud can affect the O-ring's ability to seal the connector and fuel filter's upper pipe.

·

Do not use tools to separate the connector and upper pipe.

·

Do not forcefully bend or twist the hose.

·

Keep the connector and pipe free from foreign matter.

·

Put the connector in a plastic bag to prevent damage and contamination.

·

If the connector and upper pipe are stuck together, pinch the connector and turn it carefully to disconnect it.




b.
A237749
2.031,0.938 2.094,0.896 false
V100135

Pull
V100136

Push


Disconnect the fuel filter from the bracket, and then disconnect the fuel main tube (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION) and remove the fuel filter.

NOTICE:
·

Check for dirt or mud contamination in the fuel hose and around the fuel hose's connector. Clean if necessary. Dirt or mud can affect the O-ring's ability to seal the connector and fuel filter's lower pipe.

·

Do not use tools to separate the connector and lower pipe.

·

Do not forcefully bend or twist the hose.

·

Keep the connector and pipe free from foreign matter.

·

Put the connector in a plastic bag to prevent damage and contamination.

·

If the connector and lower pipe are stuck together, pinch the connector and turn it carefully to disconnect it.




Hide 5.INSTALL FUEL FILTER ASSEMBLY

a.
B378010
2.344,0.906 3.01,0.906 false 3.052,0.813 3.365,1.01 0.313,0.198 10 false *a
*a Arrow


Face the arrow on the fuel filter upward and connect the fuel main tube to the lower pipe of the fuel filter (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION), and then connect the fuel filter to the bracket.

NOTICE:
·

Before connecting the fuel main tube connector to the lower pipe of the fuel filter, check the connector for damage and foreign matter.

·

Make sure that the fuel filter is installed with the arrow facing upward.




b.

Connect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION).

NOTICE:

Before connecting the fuel hose connector to the upper pipe of the fuel filter, check the connector for damage and foreign matter.



Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7.INSPECT FOR FUEL LEAK (for Fuel Main Tank)