1.INSTALL CHECK VALVE GASKET
Apply a light coat of gasoline to a new check valve gasket, then install it.
2.INSTALL FUEL PUMP
Insert the fuel pump.
3.INSTALL NO. 2 FUEL TUBE SUB-ASSEMBLY
| *1 | Mark |
| *2 | Clamp |
Connect the No. 2 fuel tube sub-assembly, then attach the claw.
Install the marked parts of the No. 2 fuel tube sub-assembly to the clamp.
Connect the fuel pump connector.
4.ADD FUEL
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
6.INSPECT FOR FUEL LEAK (for Fuel Sub Tank)