1.INSTALL FUEL TANK TO FILLER PIPE HOSE
Install the fuel tank to filler pipe hose to the fuel tank.
2.INSTALL FUEL TANK BREATHER HOSE
Install the fuel tank breather hose to the fuel tank.
3.INSTALL NO. 2 FUEL TANK PROTECTOR
Install the 3 fuel tank protector cushions as shown in the illustration.
Attach the 2 claws to install the protector.
4.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
5.INSTALL FUEL PUMP GAUGE RETAINER
6.INSTALL VENT LINE TUBE
Connect the vent line hose and install the vent line tube.
7.INSTALL NO. 1 FUEL TANK CUSHION
Install 2 new fuel tank cushions.
Install the clip to the cushion on the front side.
Install only 1 clip so that the cushion can be folded back and the wire harness can be installed when the fuel tank assembly is installed to the vehicle.
8.INSTALL NO. 1 FUEL TANK HEAT INSULATOR
Install the No. 1 fuel tank heat insulator with 4 clips and nut.
9.INSTALL FUEL TANK ASSEMBLY
Set the fuel tank on an engine lifter and lift up the engine lifter.
| *1 | Fuel Tank Cushion | *2 | Wire Harness |
| *3 | Fuel Tank | - | - |
Do not allow the fuel tank to contact the vehicle, especially the differential.
Be careful not to cut the wiring.
Fold back the 2 cushion rubbers.
Attach the wire harness to the 6 clamps and fuel pump and sender gauge connector.
Install the cushion rubber to the front side with the remaining clip.
Install the 2 fuel tank bands with the 2 pins and 2 clips.
Connect the 2 fuel tank bands with the 2 bolts.
10.INSTALL FUEL TANK INLET PIPE SUB-ASSEMBLY
Install the fuel tank inlet pipe with the bolt.
11.CONNECT FUEL TANK TO FILLER PIPE HOSE
Connect the fuel tank to filler pipe hose to the fuel tank inlet pipe.
12.CONNECT FUEL TANK BREATHER HOSE
Connect the fuel tank breather hose to the fuel tank inlet pipe.
13.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY AND FUEL TANK RETURN TUBE
Connect the fuel tank main tube (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
Connect the fuel tank return tube (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
Connect the vent line hose.
14.INSTALL NO. 3 FUEL TUBE CLAMP
Install the tube clamp to the fuel tube.
15.INSTALL NO. 1 FUEL TANK PROTECTOR
Install the No. 1 fuel tank protector with the 4 nuts.
16.INSTALL FUEL TANK CAP ASSEMBLY
17.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
18.INSPECT FOR FUEL LEAK (for Fuel Main Tank)