1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE AUXILIARY FUEL TANK ASSEMBLY
Disconnect the connector and No. 3 fuel hose.
Disconnect the fuel sender gauge connector.
Disconnect the No. 4 fuel hose.
Disconnect the fuel pump connector.
Disconnect the No. 2 fuel tank filler tube.
Remove the 2 bolts and auxiliary fuel tank assembly.
Do not drop the auxiliary fuel tank.
Do not damage the piping or wiring.
4.REMOVE SOLENOID VALVE ASSEMBLY
Disconnect the hose.
Remove the bolt and solenoid valve assembly.
5.REMOVE FUEL TANK FILLER PIPE SUPPORT
Remove the No. 1 fuel tank filler pipe support and No. 2 fuel tank filler pipe support.
6.REMOVE FUEL TANK CAP ASSEMBLY
7.REMOVE FUEL TANK CAP COVER
Remove the tie wrap and fuel tank cap cover.
8.DRAIN FUEL
9.REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY
10.REMOVE FUEL PUMP
11.REMOVE CHECK VALVE GASKET
12.REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY
13.REMOVE FUEL TANK FILLER PIPE
Loosen the hose clamp, then remove the fuel tank filler pipe.
14.REMOVE BREATHER TUBE FUEL HOSE
Loosen the hose clamp, then remove the breather tube fuel hose from the fuel tank sub-assembly.