1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.REMOVE INTAKE AIR SURGE TANK
5.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
Disconnect the No. 1 fuel pipe (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).
6.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY
Disconnect the No. 2 fuel pipe (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).
7.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Disconnect the 6 fuel injector connectors.
Remove the 6 bolts and fuel delivery pipe together with the 6 fuel injectors.
Be careful not to drop the injectors when removing the fuel delivery pipe.
8.REMOVE FUEL INJECTOR ASSEMBLY
Pull out the 6 fuel injectors from the delivery pipe.
Remove the O-ring and injector vibration insulator from each fuel injector.