1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.DISCONNECT CHARCOAL CANISTER ASSEMBLY
5.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
Detach the No. 1 fuel pipe from the fuel filter.
Disconnect the No. 1 fuel pipe (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).
6.DISCONNECT FUEL MAIN TUBE
Remove the fuel main tube (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).
7.REMOVE FUEL FILTER
Remove the 3 nuts and fuel filter.
8.INSTALL FUEL FILTER
Install the fuel filter with the 3 nuts.
9.CONNECT FUEL MAIN TUBE
Connect the fuel main tube (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).
10.CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
Connect the No. 1 fuel pipe (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Attach the No. 1 fuel pipe to the fuel filter.
11.CONNECT CHARCOAL CANISTER ASSEMBLY
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
13.INSPECT FOR FUEL LEAK