1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.REMOVE FUEL TANK CAP ASSEMBLY
5.REMOVE NO. 3 FUEL TUBE CLAMP
Remove the No. 3 fuel tube clamp from the fuel tube.
6.DISCONNECT FUEL MAIN TUBE AND FUEL RETURN TUBE
Disconnect the fuel main tube and fuel return tube (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Disconnect the vent line hose.
7.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Disconnect the filler pipe hose from the fuel tank filler pipe.
8.DISCONNECT FUEL TANK BREATHER HOSE
Disconnect the breather hose from the fuel tank filler pipe.
9.REMOVE FUEL TANK FILLER PIPE
Remove the bolt and filler pipe.
10.REMOVE FUEL TANK ASSEMBLY
Place a engine lifter under the fuel tank.
Remove the 2 bolts, 2 clips, 2 pins and 2 No. 1 fuel tank bands.
Slightly lower the engine lifter.
Be careful not to cut the wiring.
| *1 | Fuel Tank Cushion |
| *2 | Fuel Tank |
| *3 | Wire Harness |
Remove the clip. Then fold back approximately half of each cushion rubber so that the wire harness can be removed in the next step.
| *1 | Claw |
Detach the wire harness from the 6 clamps shown in the illustration.
Detach the claw of the clamps labeled A in the illustration to detach the wire harness.
Disconnect the fuel pump connector.
11.REMOVE NO. 1 FUEL TANK HEAT INSULATOR
| *1 | Needle-nose Pliers |
| *2 | Clip |
| *3 | Nut |
Using needle-nose pliers, remove the 4 clips and nut as shown in the illustration, and then remove the No. 1 fuel tank heat insulator.
12.REMOVE NO. 1 FUEL TANK CUSHION
Remove the clip and No. 1 fuel tank cushions.
13.REMOVE NO. 2 FUEL TANK CUSHION
Remove the No. 2 fuel tank cushion.
14.REMOVE FUEL PUMP GAUGE RETAINER
15.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
16.REMOVE NO. 2 FUEL TANK PROTECTOR
Detach the 2 claws and remove the protector.
17.REMOVE FUEL TANK BREATHER HOSE
Remove the fuel tank breather hose from the fuel tank.
18.REMOVE FUEL TANK TO FILLER PIPE HOSE
Remove the fuel tank to filler pipe hose from the fuel tank.