Home › Engine / Hybrid System › 2KD-FTV EMISSION CONTROL › DIFFERENTIAL PRESSURE SENSOR › from 2012.04
RM1840EF _51 Engine / Hybrid System _009583 2KD-FTV EMISSION CONTROL _0052282 DIFFERENTIAL PRESSURE SENSOR G

2KD-FTV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine / Data List / DPNR Differential Pressure.

Powertrain > Engine > Data List
Tester Display
DPF Differential Pressure
50003 61 238

e.

Disconnect the No. 6 exhaust pipe air hose from the sensor.


f.
A244978
0.896,1.698 1.042,1.698 1.042,1.698 1.271,2.063 false 0.552,1.635 0.865,1.792 0.313,0.156 10 false SST 2.177,1.198 2.375,1.354 0.198,0.156 10 false *b 2.021,2.677 2.219,2.833 0.198,0.156 10 false *a
*a Pressure
*b Front Side of Vehicle


Using SST, apply pressure to the differential pressure sensor.

SST
09992-00242  


g.

Check the pressure value of the sensor.

Standard pressure:

Approximately the same pressure as the applied pressure indicated on the tester.


HINT:

Perform the inspection by applying a pressure within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).


If the result is not as specified, check the sensor circuit (See page Engine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>P2454).


h.

Connect the No. 6 exhaust pipe air hose to the differential pressure sensor.