Home › Engine / Hybrid System › 1KD-FTV EMISSION CONTROL › EMISSION CONTROL SYSTEM(for i-ART) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009584 1KD-FTV EMISSION CONTROL _0052292 EMISSION CONTROL SYSTEM(for i-ART) G

1KD-FTV EMISSION CONTROL  EMISSION CONTROL SYSTEM(for i-ART)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK SEATING OF EGR VALVE

a.

Check that the engine starts and idles.


b.

Stop the engine.


Hide 2.CHECK EGR VALVE OPERATION

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Enter the following menus: Powertrain / Engine / Active Test / Control the EGR Step Position.

Powertrain > Engine > Active Test
Tester Display
Control the EGR Step Position
50004 61 95

d.

Check the values of Target EGR Position and Actual EGR valve pos in the Data List.

OK:
Control Range Condition Specified Condition
Active Test performed (Set EGR position to 0% → 30% → 60% → 90% → 60% → 30% → 0%) Actual EGR valve opening percentage changes according to Active Test operation


If the result is not as specified, refer to DTC P042E (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for i-ART)>P042E).


Hide 3.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil dipstick, filler cap, PCV hose and other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.



If the result is not as specified, replace parts as necessary.