Home › Engine / Hybrid System › 2KD-FTV INTAKE / EXHAUST › INTAKE MANIFOLD(w/ EGR Cooler) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009590 2KD-FTV INTAKE / EXHAUST _0052341 INTAKE MANIFOLD(w/ EGR Cooler) A

2KD-FTV INTAKE / EXHAUST  INTAKE MANIFOLD(w/ EGR Cooler)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 6.REMOVE MANIFOLD STAY WITH VACUUM SWITCHING VALVE

a.
A148131

Disconnect the 2 vacuum switching valve connectors and the 3 vacuum transmitting hoses.


b.

Remove the 2 bolts and manifold stay with vacuum switching valve.


Hide 7.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

a.

Remove the engine oil level dipstick.


b.
A148132

Remove the bolt and injection pipe clamp.


c.

Remove the bolt and engine oil level dipstick guide.


d.

Remove the O-ring from the engine oil level dipstick guide.


Hide 8.REMOVE ELECTRIC EGR CONTROL VALVE WITH NO. 2 EGR VALVE AND EGR COOLER

Hide 9.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 10.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 11.REMOVE NO. 3 INTERCOOLER SUPPORT BRACKET

a.
A149935

Remove the bolt and No. 3 intercooler support bracket.


Hide 12.REMOVE INTAKE MANIFOLD INSULATOR

a.
A148158

Remove the 2 bolts and intake manifold insulator from the intake manifold.


Hide 13.REMOVE INTAKE MANIFOLD

a.
A148133

Disconnect the vacuum hose and vacuum switching valve connector.


b.

Remove the 4 bolts, 2 nuts, intake manifold and gasket.