Home › Engine / Hybrid System › 2KD-FTV INTAKE / EXHAUST › EXHAUST MANIFOLD W/ TURBOCHARGER(w/ EGR Cooler) › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009590 2KD-FTV INTAKE / EXHAUST _0052344 EXHAUST MANIFOLD W/ TURBOCHARGER(w/ EGR Cooler) A

2KD-FTV INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER(w/ EGR Cooler)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 4.REMOVE NO. 1 ENGINE UNDER COVER

Hide 5.REMOVE NO. 2 ENGINE UNDER COVER

Hide 6.REMOVE FRONT WHEEL RH

Hide 8.REMOVE FRONT FENDER APRON SEAL UPPER

a.

Remove the 5 clips and front fender apron seal upper.


Hide 9.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and front fender seal.


Hide 10.REMOVE AIR CLEANER ASSEMBLY

a.
A099628

Disconnect the mass air flow meter connector and detach the wire harness clamp.


b.

Loosen the hose clamp of the compressor inlet elbow.


c.

Remove the 2 bolts and air cleaner.


d.

Loosen the hose clamp and remove the No. 1 air cleaner hose.


Hide 11.REMOVE VENTILATION PIPE

a.

Remove the bolt and disconnect the 2 ventilation hoses and ventilation pipe.


Hide 12.REMOVE COMPRESSOR INLET ELBOW

a.

Loosen the clamp, and then remove the compressor inlet elbow and air cleaner hose from the turbocharger.


Hide 13.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A148148

Remove the 2 bolts and No. 1 exhaust manifold heat insulator.


Hide 14.REMOVE TURBINE OUTLET ELBOW

a.
A148149

Remove the 4 nuts, turbine outlet elbow and gasket.


Hide 15.REMOVE TURBOCHARGER STAY

a.
A148176

Remove the 2 bolts, nut and turbocharger stay.


Hide 16.REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY (w/ Intercooler)

a.
A148151

Remove the 2 bolts, 2 nuts, union bolt, turbo oil inlet pipe and 3 gaskets.


Hide 17.REMOVE TURBOCHARGER SUB-ASSEMBLY (w/ Intercooler)

a.
A148152

Remove the 3 nuts, turbocharger and gasket.


Hide 18.REMOVE EXHAUST MANIFOLD

a.
A252010

Remove the 8 nuts, 8 plate washers, 8 collars and exhaust manifold as shown in the illustration.